Pugdemonium: Beaded Wire Wrap Bracelet

Just posted a new video, a tutorial for making a beaded wire wrap bracelet. I had some wire and beads lying around and I was trying to think of a simple way to create something using only the wire and beads, and this bracelet is the result. After I made it, I realized it is kinda like a wire version of the Chan Luu inspired wrap bracelets that are so popular. This was not my intention when I made it though, it just ended up that way. Serendipity, I guess! This project is pretty simple and quick to make, I hope you enjoy it! :)

Here are the written instructions from the video:

You will need: Size 8 beads, 20 gauge wire, 28 gauge wire, needle nose pliers, a tape measure, and wire cutters.

Step 1: Measure your wrist loosely, then add an inch and a half (3.81 cm) to the measurement. (For larger wrists, add at least 2 inches (5.08 cm) to be safe – it’s better to have extra wire than not enough). Write this measurement down.

Step 2: Double the amount from Step 1, then measure and cut this amount of the 20 gauge wire.

Step 3: Carefully bend the 20 gauge wire in half. Make sure the bent end is rounded.

Step 4: Take the amount from Step 1, and multiply it by 4.5 inches (or 11.43 cm). Then, measure and cut this amount of 28 gauge wire.

Step 5: Take the end of the 28 gauge wire, and tightly wrap it three times around the 20 gauge wire, right below the loop end.

Step 6: Slide 3 beads onto the 28 gauge wire.

Step 7: Tightly wrap the 28g wire twice around the 20g wire, on the opposite side, just under the loop. Make sure to keep the beads as snug with the wire as possible.

Step 8: Slide 3 beads onto the 28g wire, and wrap it twice onto the opposite side of the 20g wire.

Step 9: Repeat this process, until the bracelet is the length of your measurement from step 1.

Step 10: Carefully bend the bracelet into an oval, then try it on your wrist. If it is not comfortable, keep adjusting the shape until it is. If it’s not long enough, add more beads.

Step 11: Once this is done, wrap the 28g around the 20g three times, then cut the 28g. Use the pliers to flatten it so there isn’t a sharp end sticking out.